Graphic installing

[SCHAFFERNOCKER]

I have been using the Polisport brand plastics and I am having serious issues getting any graphics to stick to them. I had this issue last winter when I tried to do a set of motosport shrouds on my kx250f. I have been using alcohol and heating them up with a blow dryer and they stick but after coming back the next day, I notice they are peeled back off and not sticking at all. I'm looking for some New tips and tricks to use before I put on my New epik set.

 

[MX Graphics]

Are you cleaning the plastic before you apply the graphics?

 

[Toddco327]

I have never heated up my plastics when i put on my graphics and never had anything peel. I think the shrinking of the plastic once is cools could be a problem.

 

[SCHAFFERNOCKER]

Are you cleaning the plastic before you apply the graphics?

Ya, I wipe them down with rubbing alcohol.

 

[MX Graphics]

I would try scrubbing the plastics with either soap or comet instead of just rubbing alcohol.

 

[MxDad567]

Use Brake Clean and I usually warm everything as well.

 

[John250]

I use the decal works cleaner first. Also leave them inside in the winter to warm up for a day or two. Never use a blow dryer. Once and a while I have to re push some corners down. But do it over and over for a day, and they stick.